Maytag MVWC450XW1 Use And Care Manual page 12

TROU BLESH OOTi NG
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
to possibly avoid the cost of a service caR.In U.S.A. http://www.maytag.com/help - In Canada www.maytag.ca
Check the following for
proper installation or
see "Using Your Washer"
section,
Feet may not be in contact with the
floor and locked.
Washer may not be level.
Load could be unbalanced.
Front and rear feet must be in firm contact with floor, and washer
must be [eve[ to operate properly, lam nuts must be tight against
the bottom of the cabinet, See "installation instructions",
Check floor for flexing or sagging. If flooring is uneven, a 3/4"
(19 mm) piece of plywood under your washer will reduce sound.
See "Level the Washer" in installation instructions,
Load dry items in loose heaps evenly around basket wall,
Adding wet items to washer or adding more water to basket could
unbalance washer,
Do not tightly pack. Avoid washing single items.
Use Bulky cycle for oversized, non-absorbent items such as
comforters or poly-filled jackets.
See "Cycle Guide" and "Using Y0ur Washer" in this Use and
Care Guide,
Clicking or metallic
noises
Gurgling or humming
Humming
Objects caught in washer
drain system.
Washer may be draining water,
Is the sensing light on?
Empty pockets before washing, Loose items such as coins could fall
between basket and tub or may block pump, It may be necessary to
ca[[ for service to remove items,
It is normal to hear metal items on clothing such as metal snaps,
buckles, or zippers touch against the stainless steel basket.
It is normal to hear the pump making a continuous humming sound
with periodic gurgling or surging as final amounts of water are
removed during the spin/drain cycles,
You may hear the hum of the sensing spins after you have started the
washers, This is normal Sensing spins will take several minutes before
water is added to the washer,
Check the following for
proper installation:
Washer not level.
Fill hoses not attached tightly.
Fill hose washers.
Drain hose connection.
Check household plumbing for leaks
or clogged sink or drain.
Washer not loaded as
recommended.
Water may splash off basket if washer is not level,
Check that load is not unbalanced or tightly packed.
Tighten filllhose connection.
Are all four fill hose flat washers properly seated?
Pull drain hose from washer cabinet and properly secure it to
drainpipe or laundry tub,
Do not place tape over drain opening.
Water can backup out of a clogged sink or drainpipe, Check all
household plumbing for leaks (laundry tubs, drain pipe, water
pipes, and faucets,)
Unbalanced loading can cause basket to be out of alignment and
cause water to splash off tub, See "Using Your Washer" for loading
instructions,
Not enough water
in washer
Load not completely covered
in water.
This is normal operation for an HE low-water washer, The load will
not be completely underwater. The washer senses load sizes and adds
correct amount of water for optimal cleaning. See "What's New under
the Lid."
IMPOI_TANT: Do not add more water to washer.
J
12