Panasonic Omnivision PV-DF2002 Operating Instructions Manual page 60

Chock the following points once a
No power...
Power turns itself off,..
No pictureor sound...
Poor picture with normal sound...
Poor sound with normal picture...
Poor TV reception...
No color or poor color...
Ghost (multiple) images...
TV programs cannot be watched...
Channel cannot be selected...
TV program cannot be recorded...
Timer recording cannot be
3erformed...
NO playbackpicture, or the playback
J pictureis noisy or contains streaks...
VCR cannot be controlled...
Unit cannot be controlled...
ACTION, PLAY, SELECT, SET
POWER, etc. buttons cannot be
selected,..
lain if you are having trouble with your unit.
• Completely insert Power Plug into an AC outlet.
• Set POWER button to ON.
• Auto power*oft (shutoff) occurs after about 5 rain. in DVD mode
with no operation, or if there is no broadcast signal in TV or
Playback mode. Turn the power back on. (P. 21,37)
Make sure your antenna system (TV or CABLE), is correctly
set. (P. 1t)
Completely insert Power Plug into an AC outlet.
Set POWER button to ON.
Adjust BRIGHTNESS, SHARPNESS, and PICTURE controls in
• e SET UP Video Adjustment. (P. 47)
• Adjust VOLUME control, (P. 22)
• Adjust SHARPNESS and PICTURE controlsin the SET UP
Video Adjustment. (P. 47)
Adjust TINT and COLOR controlsin the SET UP Video
Adjustment. (P. 47)
• Install adirectional antenna.
• Make sure the selected channel is in unit's memory. (P. 16)
• Only the channel begin recorded can be viewed on this unit.
Make sure your antenna system (TV or CABLE), is correctly
set. (P. 11)
Make sure cassette record tab is intact. (P. 4)
Check that clock is set to current time and date.
Make sure DSS/CABLE box (if used) is lefton and tuned to
channel to be recorded.
Set recording Start]Stop times correctly.(P. 30, 31)
Timer recording may not be performed or continued if a power
interruption of more than 1 minute occurs before or during a
Timer Recording, even after power is restored.
Adjust TRACKING control in either direction. (P. 6)
Try Head Cleaning. (P. 6)
Make sure VCR LOCK is set to oft. (P. 39)
• Aim Remote directly at the remote sensor on the unit. (P. 10)
• Avoid any object blocking signal path.
• Inspect the remote batteries. (P. 4)
Make sure VCR LOCK is set to off. (P. 39)
Exposing unit remote sensor to direct fluorescent or outdoor
light may cause signal interference,
• Press v_. for TVoVCR mode. (P. 32)
Press DVD for DVD mode. (P. 32)
Press FM for FM mode. (P. 32)
• Check remote batteries.
6O