Maytag TM-1 User Manual page 4

}
REFRIGERATOR D OORHANDLE WITHOUTEXTENSION TRIM
e
ALIGN HANDLE OVER SCREW NO. 2 PHILLIPS
HOLES. FIRST INSTALLTHE "A" SCREW DRIVER
SCREW TO SECURE HANDLE, IS REQUIRED
FOLLOWED BY THE "B" SCREW. FOR
(tF NEEDED)
Door should be level when the cabinet is
level.
• The freezer door is too high.
Remove
Loosen h_,ge cap
_._" D 0 NOT 0 VER TIG H TE N. INSTALL ATI ON. screw s=,,,_._-__
SNAP EXTENSION INTO -- -
PLACE AT THE BOTTOM O _ _]_ 5/t6''
OF THE HANDLE. INSTALL SCREW IN
HANDLE HOLE. DO
NOT OVER TIGHTEN.
TOPMOUNTHANDLEINSTALLATION I NSTRUCTIONS
TOPOF FREEZER DOOR
ALIGN HANDLE OVER SCREW HOLES. / _-_ NO. 2PHILLIPS
FIRST INSTALL THE "A"SCREWS TO I I I__{ I I SCREW DRIVER
SECURE HANDLE, FOLLOWED BYTHE \ ] I IS REQUIRED
"B" SCREWS. DO NOT OVER TIGHTEN. \ I ! FOR
INSTALLATION.
NOTE:ALL HANDLE T,EDOWN I \11
SCREW HOLES AT THE TOP
AND I
\II
BOTTOM OF THE DOORS ARE SIZED I \1_
FOR SELF THREADING SCREWS. DO I _'_
NOT DRILL THEM TO A LARGER SIZE. I iA
REFRIGERATOR D OORHANDLE WITHEXTENSION TRIM
NO. 2 PHILLIPS SCREW DRIVER IS
REQUIRED FOR INSTALLATION,
O
SNAP TOP OF EXTENSION
INTO PLACE AT THE
BOTTOM OF THE
HANDLE.
OALIGN HANDLE OVER SCREW
HOLES. FIRST INSTALL THE "A"
SCREW TO SECURE HANDLE,
FOLLOWED BY THE "B" SCREW.
DO NOT OVER TIGHTEN.
_JP ON CERTAIN MODELS
REMOVE BACKING
FROM TAPE.
AFTER
STEP 5
APPLY
PRESSURE.
INSTALL SCREW IN HANDLE
HOLE. DO NOT OVER TIGHTEN.
e SLIDE HANDLE
EXTENSION OVER
BRACKET AT
BOTTOM OF
DOOR.
- , , _,,,Foam door
-- spacer-
DO NOT
discard
I !
• Both doors are too high.
!
!
Remove
LcOrOSwe_...= ,;_ h_ ge cap
Loosen screws and slide
lower hinge right to lower deers.
• Both doors are too low.
Remove
Loosen screws_ h_ge cap
Loosen screws and slide
lower hinge left to raise doors,
• Retighten screws after making
adjustments.
* Refer to installation instructions for
more information.