Panasonic Palmcorder PalmSight PV-L779 Operating Instructions Manual page 12

Supplying Power
i: J_ | (;.] iv| :{:'_ ii[_,.,,,] i n
This feature completely discharges Battery before recharging begins.
Use after about every 5 charges for optimum Battery performance.
CHARGE Lamp
1
@
Plug i'n,AC Adaotor.
• POWER Lamp stays on as long as
Adaptor is plugged in.
1
Place _ into Adaptor.
3
4
Press BATTERY REFRESH.
The CHARGE Lamp flashes durinQ
discharge then stays lit until charging
is complete.
If BA-I-IERY REFRESH is pressed
by mistake, remove Battery from
Adaptor and reinsert it for normal
charging.
Remove Battery.
• Charging takes about 7 and 1/2 hours
when Battery Refresh is used.
• Battery will not operate in extremely high
temperatures.
Caution:
• Charge only with specified charger.
• Battery can be charged within a temperature
range of 50 ° F (10 ° C) and 95 ° F (35" C).
• Battery is normally warm after charging or just
after use.
• Do not use an insufficiently charged or worn-
out Battery.
Safety precautions:
• Do not get Battery near, or dispose of in fire,
• Do not directly connect (short circuit) the
positive (+) and negative (-) terminals.
• Never attempt to disassemble or reassemble
Battery.
To avoid Battery damage:
• Do not drop or jar Battery.
• Use Battery with specified units only.
• If Battery is used in extremely high
temperatures, a safety device will
automatically prevent operation,
To prolong Battery life:
• While not in use, remove Battery from the
Ca_corder and AC Adaptor and store in a
cool, dark, dry place.
• Keep Battery terminals clean.
_, U.S.A. CONSUMERS: 1
ATTENTION:
The product you have purchased is powered by a nickel cadmium battery which is
recyclable. At the end of its useful life, under various state and local Jaws,it is illegal to
dispose of this battery into your municipal waste stream. Please call 1-800-8-BAI-rERY
for information on how to recycle this battery.