Panasonic Omnivision PVQ-V200 Operating Instructions Manual page 16

Search System
Each time a recording is made, an invisible index mark is placed on the tape. When timer recordings are made,
program index and information are also included. These index marks can be used to access or scan recordings.
It is easy to locate the end of a recorded program allowing you to continue
recording where you left oft.
SEARCH
1 Display SELECT SEARCH
i MODE in Stop or PJay mode. Press SEARCH.*
2
SELECT SEARCH MODE
ZERO SEARCH
LNePE_ SEARCH __
SELECT:& • KEY
SET :, KEY
END :SEARCH KEY
Select PROGRAM END
SEARCH.
_ 1) Press iV to select.
_,_ 2)Press I_ to
start search.
Examples of Program End Search operation.
ItTPro0ram, I[]i Pro0ram2orB'A.<
the current tape position _ _.
Press SEARCH button / _' End Point
/
FF
II
F_ ___l Pr0graml
_e!CsU_n_a_bPO_iotinonlll _,ANK I m
Program 2 Ill_BLANKEnd Pointll
i
FF
the current tape position
Press SEARCH button
few seconds in
End Point FF BLANK area.
_@o
-2 SELEC
SET
• :PLAY
• :STOP
IP :FF
-1
SEARCH
If Program End Point ('=_i_l)is found.
The search continues slightly beyond the end point, then search and reverse search
and plays the last few seconds of the program and finally stops.
liT R,egramt ti!t Rrog,o_,_,AN_> II
the current tape position i
Press SEARCH button i SEARCH
FF F'LAY,_--_ ! REVERSE SEARCH
,_.._ . ...... _......... •
STOP
• If Program End Search is started
very close to an index mark, one
program may be skipped over.
• To cancel Program End Search,
press PLAY or STOP.
16
il,]i _l-'!--ll.-I_lil_,i;.1. [_-II ll!:lllilti illll'_lll_'!lrM_I_.l