Panasonic Omnivision PVQ-V200 Operating Instructions Manual page 14

The Remote Control may be set up to control some TV or Cable/DSS Box functions.
Find your TV, Cable or DSS Receiver Brand
Code Number on following page.
Setup for TV G3 (3D (Z)
and (Z3QDQD
Setup for Cable or DSS
Q and QD GD QD
(Z3QD
GDCD
Setup remote.
Hold down TV and enter code
with NUMBERED keys.
Hold down DSS/CABLE and
enter code with NUMBERED keys.
• For code 100 or greater, press the
100 key first, then remaining digit.
E.g. for 102, press 100, then press 0,
and then press 2.
Confirm code entry.
Press POWER to turn selected
unit ON or OFF.
• See table below for list of
controllable functions in each mode.
O. Please repeat Multi-Brand Control setup after replacing remote
control batteries.
• The remote control will not operate all TVs, Cable Boxes, and
DSS receivers made by manufacturers listed. It you get no
results, your particular brand cannot be controlled.
POWER
2 DT sC;c
NUMBERED
After remote control is setup, you can select VCR, TV, or DSS/CABLE for the desired function,
Press MCR or TM or DSS/CABLE on the remote control.
This table shows which buttons are available for each mode.
ailable
s VCR TV
VCR All Functions VOL UP/DOWN
rv
CABL_ DSS
VCR/TV, PLAY, STOP
EJECT, DISPLAY,
FF, REW, PAUSE/SLOW,
REC, SPEED, COUNTER
RESET, TAPE POSITION,
CMSKIP
VCR/TV, PLAy, STOP
EJECT, DISPLAY, FF,
REW, PAUSE/SLOW,
REC, SPEED, COUNTER
RESET, TAPE POSITION,
CM SKIP
POWER, INPUT,
NUMBERED keys,
ENTER, CH UP/DOWN,
VOL UP/DOWN
VOL UP/DOWN
CABLE/DSS
POWER, ENTER,
NUMBERED keys
(except 100key),
CH UP/DOWN
_ln TV or OSS/CABLE mode, it may be necessary to press ENTER after pressing NUMBERED keys for channel selection.
]4
_o] m:._.-_.-_ I--t_.;i[,.[=+=_ ill liB:[0Z0]P.lii [] __,__V:_IFJ,',[ ,_4