Installation - Panasonic PanaMedia PM15 Operating Instructions Manual

Installation
The signat cable connections differ depending on what computer you are using.
When connecting to an IBM compatible, and when connecting to an Apple computer, connect
as shown below. When connecting to any other system, please read that system's operation manual,
1 Please read the Operation Manual thoroughly before installing the display monitor,
Y
2 Before connecting to a computer, always tum the computer power OFF.
< IBM compatible > < MAC >
3 Is the computer to be connected an IBM 3 If you are using a Macintosh, please purchase a
compatible? Macintosh conversion adapter separately.
Vy
Connect a MAC conversion adapter to the signal
Connect tha accessory video cabia to the video cabie connector connected to the computer side.
connector on the display monitor rear panel ter- 4 Then connect the connector at the other end of
minal post, then connect the other end to the the cable to the video connector on the display
computer video output connector. monitor rear panel terminal post
mac adapter
Panasonic MAC adapter
Mac i
| 13" | 640 X 480 } UNIMAC-82D
Connect the power cord to the monitor, 832X624 | UNIMAC-82D
and plug the other end into an electri- | | 19" |1024X768 [UNIMAC-82D
cal outlet. For UNIMAC-82D adapters
consult your dealer or
ay 1-800-PANASYS.
6 Turn the display monitor power switch ON, then turn the computer switch ON.
7 Reterring to the operation instructions on page 9, sel your desired settings.
If the AC power supply voltage is in the range 100V to 240V, either 50Hz or 60Hz frequency can be used.
There is no AC100V/240V selector switch.
Caution
«To use the display unit safety, use a power cord with a ground wire and always ground the ground wire.
«Always use the AC cords listed below for each area,
U.S.A ... UL Canada ... CSA
in other regions, for safety please use an AC plug cord that complies with each country's safety regulations.