Remote Control Battery Installation - Panasonic PT-50LC13 Operating Instructions Manual

Before Using
Accessories
1. Remote Control
2. Batteries 2 "AA"
3. RGBCable (2 m)
4. DVI Cable (2 m)
(EUR7603ZB0)
(LSJA0239-1 or LSJA0443)
(K1HA24DA0003)
Remote Control Battery Installation
Requires two AA batteries (supplied).
1.
Turn the Transmitter face down.
Remove top cover by pressing
down on marking and sliding
cover off in the direction indicated.
2. Install the batteries as shown in
the battery compartment
(Polarity + or - must match the
markings in the compartment).
3 Replace the cover and slide
in reverse until the lock
snaps.
Incorrect battery installation can cause the batteries to leak, leading to personal injury and/or damage to the remote
control.
Observe the following precautions:
1. Batteries should always be replaced as a pair Always use new batteries when replacing the old set
2. Do not mix battery types (example: "Zinc Carbon" with "Alkaline").
3. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
4. Battery replacement is necessary when the remote control acts sporadically or stops operating the projection
display set.
(1) For frequent remote control users, replace old batteries with Alkaline batteries for longer battery life.
(2) Whenever you remove the batteries, you may need to reset the remote control infrared codes. We
recommend that you record the code on page 70, prior to setting up the remote.