Table of Contents
Advertisement
14. Lightning -- For added protection of this video unit
receiver during a lightning storm, or when it is left
unattended and unused for long periods of time, unplug it
from the wall outlet and disconnect
the antenna or cable
system. This will prevent damage to the video unit due to
lightning and power-line surges.
15. Power Unes -- An outside antenna system should not be
located in the vicinity of overhead power lines or other
electric light or power circuits, or where it can fall into
such power lines or circuits. When installing an outside
antenna system, extreme care should be taken to keep
from touching such power lines or circuits as contact with
them might be fatal.
16. Overloading -- Do not ovedoad wall outlets and
extension cords as this can result in a risk of fire or
electric shock.
17. Objects and Liquids -- Never push objects of any kind
into this video unit through openings as they may touch
dangerous voltage points or Short out parts that could
result in a fire or electric shock. Never spill liquid of any
kind onto the video unit.
18. Servicing -- Do not attempt to service this video unit
yourself as opening or removing covers may expose you
to dangerous voltage or other hazards. Refer all servicing
to qualified service personnel.
19. Damage Requiring Service -- Unplug this video unit from
the wall outlet and refer servicing to qualified service
personnel under the following conditions:
a.
When the power-supply
cord or plug is damaged.
b.
If any liquid has been spilled onto, or objects have
fallen into the video unit.
c.
If the video unit has been exposed to rain or water.
d.
If the video unit does not operate normally by
following the operating instructions. Adjust only those
controls that are covered by the operating
instructions, as an improper adjustment of other
controls may result in damage and will often require
extensive work by a qualified technician to restore
the video unit to its normal operation.
e.
If the video unit has been dropped or the cabinet has
been damaged.
f.
When the video unit exhibits a distinct change in
performance -- this indicates a need for service.
20. Replacement
Parts -- When replacement
parts are
required, be sure the service technician has used
replacement parts specified by the manufacturer
or have
the same characteristics
as the original part.
Unauthorized
substitutions may result in fire, electric
shock or other hazards.
21. Safety Check--
Upon completion of any service or
repairs to this video unit, ask the service technician to
perform safety checks to determine that the video unit is
in safe operating order.
USE & LOCATION
• TO AVOID SHOCK HAZARD ... Your Camcorder and power supply should not be exposed to rain or moisture.
Do not connect the power supply or operate your Camcorder if it gets wet. Your Camcorder has been designed
for outdoor use, however it is not designed to sustain direct exposure to water, rain, sleet, snow, or a direct
splashing from a pool or even a cup of coffee. Do not attempt to disassemble this unit. There are no user
serviceable parts inside. Unplug your Camcorder from the power supply before cleaning.
• DO NOT AIM YOUR CAMCORDER AT THE SUN OR OTHER BRIGHT OBJECTS
° DO NOT EXPOSE YOUR CAMCORDER TO EXTENDED HIGH TEMPERATURE
... Such as, in direct
sunlight, inside a closed car, next to heater, etc... This action could permanently damage the internal parts of
your Camcorder.
• AVOID SUDDEN CHANGES IN TEMPERATURE
... If the unit is suddenly moved from a cold place to a warm
place, moisture may form on the tape and inside the unit.
° DO NOT LEAVE YOUR CAMCORDER OR THE POWER SUPPLY TURNED ON WHEN NOT IN USE
• STORAGE OF YOUR CAMCORDER
... Store and handle your Camcorder in a manner that will not subject it to
unnecessary movement (avoid shaking and striking). Your Camcorder contains a sensitive pick-up device which
could be damaged by improper handling or storage.
CARE
• TO CLEAN YOUR CAMCORDER
... Do not use strong or abrasive detergents when cleaning your Camcorder
body.
• TO PROTECT THE LENS ... Do not touch the surface of the lens with your hand. Use a commercial camcorder
lens solution and lens paper when cleaning the lens. Improper cleaning can scratch the lens coating.
° TO PROTECT THE FINISH OF YOUR CAMCORDER
... Before handling your Camcorder, make sure your
hands and face are free from any chemical products such as suntan lotion as it may damage the finish.
4
Hide quick links:
Advertisement
Table of Contents
