LG LTC22350ST Owner's Manual page 14

• At this point, remove the Decorative Bolt on bottom on
refrigerator housing from the left side of refrigerator
(Fig. 24). You will need this hole for the Bottom Hinge.
Fig. 24
• Move the Bottom Hinge to the left side of housing keeping
the same orientation, and reattach with 3 bolts (Fig. 25).
Now move Decorative Bolt to hole on lower right side
of housing.
Fig. 25
* Turn refrigerator door upside down on a nomscratching
surface,
. With door upside down, loosen the 2 screws and remove
the Door Closer/Stop (Fig. 26), then loosen the other two
screws to remove the bottom Hinge Pin Insert Bracket with
Hinge Pin Insert (see Fig, 27).
Fig. 26
oor Closer/Stop
• Take out the Hinge Pin insert and move the Bracket to
the other side of the door, keeping the same orientation
(Fig. 28).
• Place Hinge Pin insert into the left side
of the bracket. Tighten Hinge Pin Bracket
to door (Fig. 28).
Fig 28
Hinge
-- Pin Bracket
Hinge Pin insert
• Take Door Closer/stop and flip (see Fig. 29). Line up
screw holes and mount on left side of door bottom with
the two screws. Turn door upright. It is now ready for re-
attaching.
Fig, 29
* With flat-head screwdriver, carefully pry off and remove
the cover over the screw holes on the left side of
refrigerator housing (Fig, 30).
Fig. 30
Fig. 27
Hinge
Pin Bracket __
Hinge Pin
Insert
•Remove the outer lower Decorative Screw from housing
at area between freezer and refrigerator d_rs (Fig. 31).
(You will need this hole for the Middle Hinge Bracket).
Fig. 3t
¢
14