NordicTrack SL 710 User Manual page 6

2, 2
8,
4,
While another person Hfts the rear of the Frame (1),
attach the Rear Stabilizer (16) to the Frame with four
M8 x 40mm Sutton Screws (54) and four M8 Split
Washers (55),
While another person hoUds the Upright (2) in the posi-
tion shown, connect the Upper Wire Harness (97) to
the Lower Wire Harness (43), Gently pull the upper
end of the Upper Wire Harness to remove any sUack
from the Wire Harnesses,
Insert the Upright (2) into the Frame (1), Be careful to
avoid pinching the Wire Harnesses (43, 97). Attach
the Upright with two MIO x 118mm Button Screws
(78), two MIO Split Washers (88), and two Upright
Spacers (99), Make sure the concave end of each
Upright Spacer is turned toward the Upright.
Udentify the Left HandUebar (70), which is marked with
an "L" sticker, While another person hoUdsthe Left
HandUebar near the Upright (2), connect the UeftPuUse
Sensor Wire (6) to the PuUseWire (3)_ Next, slide the
Left HandUebar onto the indicated tube on the Upright,
Be careful to avoid pinching the Wires. Carefully
insert two M8 x 40mm Button Bolts (81) through the
Left Handlebar and the tube on the Upright, Be care-
ful not to damage the Wires with the Button Botts.
Finger tighten two M8 Nylon Locknuts (89) onto the
Button Bolts, Next, slide the Handlebar Collar (100)
onto the upper end of the Left Handlebar,
Attach the Right Handlebar (72) as described above,
Note: As you slide the Right Handlebar onto the right
tube on the Upright (2), insert the upper end of the
Right Handlebar into the Left Handlebar (70),
Connect the Handlebars (70, 72) with the Handlebar
Collar (100) and an M4 x 16mm Screw (57), Tighten
the four M8 x 40mm Button Bolts (81), Make sure the
M8 Nyton Locknuts (89} are seated in the he×ago-
naJ hotes in the Handlebars.
78
\
\
\
70
54
97
43
99
Make sure the wires
do not get damaged
during this step.
Make sure the
wire harnesses
do not get
pinched and
damaged during
this step.
81
2
\
Tube
\
6 3\
72
\
\ 89 N
\
\
\
\
\
\
\
\