Unpacking Instructions - Murray 22106X9A Instruction Book

PREPARATION
UNPACKING INSTRUCTIONS
The mower was fully assembled at the factory.
When the mower was put in the carton, the
handle was put in the storage position. To put
the handle in the operating position, follow the
steps below.
1. Remove the mower from the carton.
2, Put the lower handle in the operating posi-
tion. Make sure the lower handle is be-
tween the locking tabs (Figure 1).
3. Put the upper handle in the operating
position. Tighten the wingnuts.
CAUTION: Be careful when you fold or
raise the handle. Do not damage the
cables. A cable that is bent will not work
correctly. Before you use the unit, re-
place a bent or damaged cable.
Lockinc
Tabs.
4. To attach the recoil-start grip to the rope
guide, twist the rope through the rope
guide mounted on the dght side of the han-
dle (Figure 2).
NOTE: If you cannot attach the
recoil-start grip because the rope is too
short, hold the engine atop lever
against the handle. Slowly pull the
recoil-start grip.
Handle
Wir
Wingnut
Offset Hole
HOWTO ADJUSTTHEHANDLEHEIGHT
The lower handle has two assembly posi-
tions. A HIGH and a LOW position (Figure 3).
The HIGH position will raise the handle ap-
proximately four inches.
LOW
The mounting holes in the lower handle are
offset (Figure 1), To change the hole offset, ro-
tate the lower handle. This will change the
F-98524
11
angle of the handle and make the heightof the
handle higher or lower (Figure 3).
1,
Remove the cable ties that fasten the con-
trol cables to the lower handle (Figure 4).
The cable ties can be re-used. To remove
a cable tie, pull the tab on the cable tie to
free the cable.
2. Remove the bolts and wingnuts that fas-
ten the upper handle to the lower handle.
3. Put the upper handle on the ground be-
hind the mower.
4.
5.
CAUTION: Do not bend the control
cables. A cable that is bent or damaged
must be replaced.
Remove the wingnuts from the right and
left handle brackets (Figure 1).
Remove the lower handle from the han-
dle brackets (Figure 1).