Mitsubishi CS-40805 Owner's Manual page 24

_Important:
_>Important:
using your remote control to operate your Mitsubishi AN
receiver
After you have set up your remote control fbr your A/V receiver, you
can use the remote to operate it.
O Use the select buttons across the top of the remote control to
choose the layer that you "set up" to operate your AN receiver:
TV or AUX.
O Point the remote control at the A/V receiver and press the
desired buttons.
If you are using a Mitsubishi HTS-100, you can use the POWER,
VOLUME, and MUTE buttons to operate the receiver.
If you are using a Mitsubishi HTS-300, you can use the POWER,
CHANNEL, INPUT, VOLUME, ENTER, nuraber (0-9), DISPLAY,
MENU, CANCEL, AUDIO, VIDEO, ADJUST, and MUTE buttons
to operate the receiver.
notes about your remote control
Sometimes manufacturers will change their :products, or they may
use more than one code. If this is the case, your remote may not be
able to operate your VCR, cable box, or audk_ component.
When you replace the batteries in your remo_e control, the remote
will usually return to its initial setting. You :may need to set up
your remote again.
Getting Started 21