Programming The Water Softener - Miele G 858 SCVi Operating Instructions Manual

Before using for the first time
15 16 17 18 19 20
Programm(ng the water softener
Your water hardness level must be
programmed into the dishwasher using
the buttons on the control pane).
The programming can be cancelled
i nd restarted at any time by turning
the dishwasher off using the "Off"
button, (16).
[] Open the door.
[] Turn off the dishwasher,
[] Press and hold the _ and @.)buttons.
At the same time turn on the
dishwasher with the "On" (!5) button.
[] Release all buttons.
The "Salt" and .'_ indicators will flash.
If this is not the case, the above steps
must be repeated.
[] Press the '_ button.
The @ indicator goes out and the "Salt"
indicator will flash.
____
(f your water hardness is greater
than 12 gr/gal (220 ppm) proceed to
the next page.
21
t - 12 gr/gaJ:
1 2 3 4 5
o_ o_ o_ o_ oqi_ o
( i
(
22
An ind)cator corresponding to a preset
water hardness will light (see Table 1).
Tab)e t :
gr/ga(*
t- 4**
5- 6
7
8-10
11-12
Button
ppm
20- 70
90- 110
130
140- 180
200 - 220
* US gallons
** Factory preset
If this value corresponds with the water
hardness in your area:
[] Turn off the dishwasher.
If you need to program a different water
hardness:
[] Press the button, which corresponds
with your water hardness (see
Table 1).
The "Salt" and _ indicators will flash.
[] Press the '_@ button twice.
The "Salt" and '_6D indicators will flash.
The new water hardness is set
[] Turn off the dishwasher.
15