Checking The Programmed Water Hardness - Miele G 858 SCVi Operating Instructions Manual

Before using for the first time
t3 - 70 gr/gaJ:
[] Press the '_ button.
The _ indicator will light.
An indicator corresponding to a set
water hardness will light (see Table 2).
Table 2:
gr/gaJ
13
14- 16
17- 22
23 - 35
36 - 70
Button
ppm
230
250- 290
310- 400
410- 630
650 - 1260
If this value corresponds with the water
hardness in your area:
[] Turn off the dishwasher.
If you need to program a different water
hardness:
[] Press the button which corresponds
to your water hardness (see Table 2).
The "Salt" and ','_ indicators will flash.
[] Press the '_@ button twice.
The "Salt" and @ indicators will flash.
The new water hardness is seL
Checking the programmed water
hardness
[] Open the door.
[] Turn off the dishwasher.
[] Press and hold the _ and @.)buttons.
At the same time turn on the
dishwasher with the "On" (!5) button.
[] Release all buttons.
The "Salt" and _ indicators will flash.
If this is not the case, the above steps
must be repeated_
[] Press the '_ button.
The programmed water hardness is
indicated by:
t =t2 gr/gaJ
Corresponding indicator is lit, (see
Table 1).
[] If an indicator is not lit, press the ,'_
button.
t3 =70 gr/gal:
The _ indicator and an additional
corresponding indicator is lit, (see
Table 2).
[] Turn off the dishwasher.
[] Turn off the dishwasher.
16