Table of Contents
Advertisement
REMOTE
KEYPAD
VCR
POWER
INPUT
STATUS
CHANNEL
UP (A)/
DOWN
(T)
TV-CATV
•
HOW TO IDENTIFY A VCR
The remote control
may already
be set to
operate your VCR. Try this initial check to see
if going on to the following "identify" section is
necessary.
(1) Point remote towards
VCR and press VCR
POWER.
(2) Does the remote turn the VCR ON and OFF?
• If yes, the remote is ready to operate the VCR
and no further steps are needed.
• If no, continue to the "identify" section.
•
To Identify Your VCR- Direct Entry Method.
Use the following steps and list to quickly find
the remote control code for your accessory
VCR.
• First look up your VCR's remote control code
number before going through the direct code
entry steps control.
• If this procedure
does
not identify
your
accessory
VCR, use the Search method of
identification
(described in the next section).
(1) Slide TV-CATVswitchtoTV.
(2) Press and hold down INPUT STATUS and
CH DOWN (Y) on your remote control.
Then release both buttons.
(3) Within
ten seconds
after releasing
INPUT
STATUS and CH DOWN (V), enter you rVCR's
two-digit remote control code number using
REMOTE KEYPAD (refer to list).
• The remote
control
is now ready to send
commands to your VCR.
Some brands have more than one remote
code listed due to changes
in the remote
codes from early to later model years, or due
to format differences
(VHS/BETA).
In such
cases, you may have to try more than one code
to find the code your VCR accepts.
I NOTE:
Depending
on the model,
year produced,
brand, and type of VCR, some models may
not be compat b e w th the remote contro.
•
To Identify
Your VCR-
Search Method.
(1) Slide TV-CATVswitch
on the remote to TV.
(2) Press POWER on the VCR to ON.
(3) Stand at least six feet away from the front of
the VCR.
Point the remote towards the VCR.
Hold down INPUT STATUS and CH UP (_,) at
the
same
time.
KEEP
HOLDING
THE
BUTTONS DOWN.
(4) Watch the Channel Number indicator on the
VCR, Channel numbers will scan up when the
VCR has been identified.
Release INPUT STATUS and CH UP (,)
as
soon as the channeI numbers start to scan up.
The VCR's remote control code number has
been identified,
and the remote is ready to
operate the VCR.
37
Advertisement
Table of Contents
