Optional Adapter Plates - Extron electronics RGB 400 Series User Manual

Part Numbers and Accessories, cont'd
Pre-cut cables
BNC-5 cables are primarily used for applications that
require RGBHV signals. BNC-4 cables are mainly used for
RGBS signals. Either can be used to route composite video,
S-video or RGB with sync on green. All of these cables
come in lengths from 3 feet to 300 feet, and all have male
BNC connectors on both ends. The BNC-5 HR cables are
also available in a plenum version.
Pre-cut high resolution cables
BNC-4-25'HR (25 feet/7.5 meters)
BNC-4-300'HR (300 feet/90.0 meters)
BNC-5-25'HR (25 feet/7.5 meters)
BNC-5-300'HR (300 feet/90.0 meters)

Optional Adapter Plates

A variety of optional adapter plates for pass-through
connections may be ordered for the RGB 408 interface. The
RGB 408 can have up to 4 adapter plates installed in one of
the following configurations:
• four adapter plates with a "plate size" of one,
• two adapter plates with a plate size of one and one
adapter plate with a plate size of two,
• or two adapter plates with a plate size of two.
The RGB 408 is shipped with two single height blank plates
(part #70-090-01/-11/-21) and one double height blank
plate (part #70-090-02/-12/-22).
The tables on the following page list some of the available
adapter plates. Contact Extron for a complete list.
Blank Plate (no connector)
Single Space
2 - BNC
3 - BNC
2 - RCA to Solder Cups
3 - RCA to Solder Cups
2 - S-video
Architectural adapter plates
RGB 400 Series Part Numbers and Accessories
D-4
Part number
26-210-04
26-210-53
26-260-03
26-260-14
Blank Plate (no connector)
Double Space
5 - BNC (Double)
2 - RJ-11
1 - D-9 Pass Through Connector
RGB 400 Series Part Numbers and Accessories D-5