Table of Contents
Advertisement
(_)perating Your Dishwasher
What happens in each option
Energy saver wash option
This option will eliminate the
water heating during the wash
portion of a cycle. The ENERGY
SAVER
Wash option should
only be used when the water
enteringthe dishwasher is 140 °F
(60°C) or higher. This optionmay
be used with the POTS/PANS, NORMAL,
and LIGHT/CHINA cycles.
Energy saver dry option
I
his option will eliminate the
heat during the dry portion of a
cycle. This option may be used
with the POTS/PANS, NORMAL,
and LIGHT/CHINA cycles.
The fan of the drying system
will continue to operate, helping
the dishes to air dry naturally. Under certain
conditions, you may find a few drops of water
on the dishes and silverware. For best drying
results, use a rinse agent.
Adding dishes during a cycle
You can add an additional item to the
dishwasher anytime before the main wash
portion of a cycle. See chart on page 8.
1. Unlatch the door to stop the cycle. Wait a
moment for the spray action to stop
before opening the door.
3. Close the door.
4. Push down on the door handle to latch
door.
5. Push the START button to restart dish-
washer.
2. Open the door and add the dishes.
Changing a cycle setting
You can change a setting anytime during
any cycle.
1. Turn the Cycle Selection dial slowly to
the drain portion of the wash or rinse.
You will hear water draining when you
have advanced to the proper location.
2. Let the dishwasher drain completely.
3. Unlatch and open the door.
5. Relatch the door.
6. Select the desired new cycle and
option(s). See page 7.
7. Push the START button.
4. Check the detergent dispenser to be sure
it is properly filled for the new cycle.
9
Advertisement
Table of Contents
