KitchenAid KUDX23HB Use And Care Manual page 22

Changing Front Panels
Lower Panel:
=
With the door closed, remove the two
screws (C) on either side of the lower
panel. Remove the loosened piece of
trim (D).
.
Slide the color panel out. Handle the panel
carefully to avoid scratching or bending the
panel. Turn the panel to the desired color.
Slide the color panel in position.
3. Replace trim (D) and two screws (C).
4. Reconnect electrical power supply.
OPTION B
Use these directions when the dish-
washer front is flush with the cabinets.
Upper Panel:
1. Disconnect electrical power supply.
2. Open the door. On each side of the door,
remove the two screws (E) which secure
the panel assembly.
:3. Close door while holding panel assembly
in place. Pull out lower edge of assembly
until top edge drops down.
o
Place panel assembly on a smooth, flat
surface. Remove three screws (A) from
either side of panel to remove the trim
strip (B).
=
Slide the color panel out. Handle the
panel carefully to avoid scratching or
bending the panel. Turn the panel to the
desired color. Slide the color panel into
position.
6. Replace the trim strip and the three
screws.
.
With hands placed at sides of panel, slide
the top edge of the panel assembly up
into position under the control panel.
8. Hold the panel assembly in place and
open the door.
9. Hold panel assembly in position with one
hand. Replace the two screws (E) on
each side of the dishwasher door.
Remove screws
and trim pieces.
Pull lower edge of
panel assembly out
and down.
A
22