Beforeyou Call - Kenmore ELITE 790.4927 Series Use & Care Manual

Table of Contents

Advertisement

General Cleaning
(continued
Turn the warmer drawer
control knob to OFF before removing
the drawer. DO NOT touch the warmer
drawer element. The element may still
be hot enough to cause burns, even if
it is dark in color.
Left Glide
Pull up latch
with finger
Push down latch
Right Glide
with finger
Warmer
Drawer
To Remove and Replace Warmer
Drawer
To Remove Warmer Drawer:
t.
_Turn
poweroff before removing the warmerdrawer.
2. Open the drawer to the fully opened position.
3.
Locate the latches on both sides of the warmer drawer.
4.
Pull up on the left glide latch and push down on the right glide latch.
5.
Pull the drawer away from the appliance.
6. To clean warmer drawer, gently scour with a soapy scouring pad, this
will remove most spots. Rinse with a t :t solution of clear water and
ammonia. If necessary, cover difficult spots with an ammonia-soaked
paper towel for 30 to 40 minutes. Rinse with clean water and a damp
cloth. Remove all cleaners or the porcelain may become damaged
during future heating. DO NOT use spray oven cleaners on the
cooktop.
To Replace Warmer Drawer:
1. Align the glide latches on both sides of the drawer with the slots on
thedrawer.
2.
Push the drawer back into the appliance.
Electrical
Shock Hazard can occur and
result in serious injury or death. Disconnect appliance
from electric power before cleaning and servicing the
warmerdrawer.
Avoid Service
Checklist
Before you call for service, review this list. it may save you time and expense.
The list includes common
occurrences
that are not the result of defective
workmanship or materials in this appliance.
OCCURRENCE
POSSIBLE
CAUSE/SOLUTION
Drawer is not level.
Poor installation. Place a level on the cutout bottom. Make sure bottom is level.
Be sure cutout bottom is strong and stable enough to adequately support drawer
(and wall oven, if applicable).
Cannot move appliance
easily.
Appliance must be accessible
for
service.
Cabinets not square or are built in too tightly. Contact builder or installer to make
appliance accessible.
Warmer drawer does not operate.
Make sure cord/plug is plugged tightly into outlet.
Service wiring is not complete. Contact Sears or another qualified servicer.
Power outage. Check house lights to be sure. Call your local electric company
for service.

Advertisement

Table of Contents
loading

This manual is also suitable for:

790.4927

Table of Contents