iNSTALLATiON
AND SERVICE MUST BE PERFORMED BY A QUALiFiED
iNSTALLER.
iMPORTANT:
SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S
USE.
READ AND SAVE THESE iNSTRUCTiONS
FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other flammable
vapors and liquids in the
vicinity
of this or any other appliance.
GENERAL INFORMATION
The Warm & Serve Drawer can be used:
•
As a stand alone appliance
As a combination 27" or 30" Warm & Serve Drawer with a 27" or 30" (76 cm) built-in oven mounted above
IMPORTANT: The warmer drawer must be installed on a surface that is leveled from left to right, rear to front, and is
capable of supporting
100 Ibs (45 Kg).
Warm & Serve Drawer
Dimensions
NOTE: A 60" (1 52 cm) long cable is supplied with the
Warm & Serve Drawer.
Stand Alone Installation
60" (152 cm)
Cord
& Serve
Drawer
271' Models
11 ¼"(28.6cm)
27"(68.6cm)
233/8"(59.4cm)
30"Models
11 ¼"(28.6cm)
30"(76.2cm)
233/8"(59.4cm)
27" Models- Min. 97/8"(25.1 cm)
25½"(64.8cm)
235/8"(60cm)
Max. 10_A" ( 26cm)
253A" ( 65.4 cm)
241' (61cm)
30"Models- Min. 97/8"(25.1 cm)
28Y2" ( 72.4 cm)
235/8"(60cm)
Max. 10_A" ( 26cm)
283A" ( 73cm)
24" (61cm)
IMPORTANT:
The Warm & Serve Drawer runs off a
single phase three-wire
120 volt, 60 hertz, AC only
electrical supply with ground.
Combination
Warm & Serve Drawer/
27" or 30" (76 cm) Built-in
Oven Installation
CAUTION:
Install two 3" (7.6 cm)
wide x 3.4" (1.9 cm) thick planks
capable of supporting
200 Ibs
(90.7 Kg)
(74_
t
H* = 11-7/8" (30,2 cm) Min. is the space between
the bottom of the warmer drawer cutout and the bottom of the
oven cutout. This is a critical dimension and must be provided.
J** = 3" (7.6 cm) Max. Electrical Junction Box for wall oven must be
lower than warmer drawer cutout.
27" Models
11¼"(28.6 cm)
27" (68.6 cm)
233/8" ( 59.4 cm)
30"Models
11¼"(28.6 cm)
30" (76.2 cm)
233/8" ( 59.4 cm)
27"-Min. 97/8" (25.1 cm)
25Y2" (64.8 cm) 235/8" ( 60 cm) 2I' ( 5.1cm)
Max. 10¼1. (26cm)
25;A" (65.4 cm)
24"(81 cm) Do,endsons_itinnl
dimension H
30"-Min. 97/8" ( 25.1 c m) 28_"(72.4 cm) 235/8" ( 60 cm) 2I'(5.1 cm)
Max. 10¼"(26 cm)
283A" (73 cm)
24" (61 cm) Dn_ends0ns,itinnl
dimension H
Printed in the USA
P/N 318201813 (0805) Rev.A
English - pages 1-2; EspaAol - p_fginas 3-4
Fran_ais - pages
5-6; Notes
- pages 7-8
Need help?
Do you have a question about the 79049212800 and is the answer not in the manual?
Questions and answers