Download  Print this page

Kenmore ELITE 790.4927 Series Use & Care Manual page 6

Hide thumbs

Advertisement

Setting Warmer
Drawer Control
Use the warmer drawer to keep hot
foods hot such as: vegetables, gravies,
meats, casseroles, biscuits and rolls,
pastries and heated dinner plates.
The warmer drawer is equipped with a
catch which may require a small amount
of force when opening and closing the
drawer.
WARMER
DRAWER
To Set theThermostat
Control
The thermostat control knob is used to select the temperature of the warmer
drawer. It is located at the right side of the warmer drawer in the open position.
The temperatures are approximate, and are designated by HI, MED and LO.
The control can be set to the three settings, or anywhere between.
OFF
MED
Indicator Light
Warmer Drawer Recommended
Food Settings Chart
Food item
Setting
Bacon
Hi
Biscuits
MED
Casseroles
MED
Eggs
MED
Empty Dinner Plates
LO
Fish, Seafood
MED
Fried Foods
HI
Gravies, creams, sauces
MED
Ham
MED
Hamburger Patties
Hi
Pancakes, Waffles
Hi
Pastries
MED
Pies
MED
Pizza
Hi
Pork Chops
Hi
Potatoes (baked)
Hi
Potatoes (mashed)
MED
Poultry
Hi
Roasts (Beef, Pork, Lamb)
MED
Rolls, soft
LO
Rolls, hard
MED
Vegetables
MED
1.
To set the thermostat, push in and turn the knob to the desired setting.
2.
For best results, preheat the drawer before adding food. An empty drawer
will reach the LO setting in about 12 minutes, the MED setting in about 15
minutes, and the HI setting in about 18 minutes.
3.
When done, turn the thermostat control to OFF.
Temperature
Selection
Refer to the chart in the side column for recommended settings.
If a particular food is not listed, start with the medium setting. If more crispness
is desired, remove the lid or aluminum foil.
Most foods can be kept at serving temperatures by using the medium setting.
When a combination
of foods are to be kept warm (for instance, a meat with
2 vegetables and rolls), use the high setting.
Refrain from opening the warmer drawer while in use to eliminate loss of heat
from the drawer. Open only for adding or removing food.
To Warm Serving
Bowls and Plates
Heat bowls and plates on the LO setting. Place empty dishes on the rack to
raise them off drawer bottom. To further heat dishes or to heat fine china,
check with the manufacturer for maximum heat tolerance.
To Set the Humidity
Controller
The humidity controller is located on the inside of the warmer drawer and used to
control humidity in the warmer d rawer. The humidity control knob can be set at any
position between Moist _.._ (Figure 1) and Crispy _0_ (Figure 2) position. To set
the humidity controller, slightly unscrew the knob, slide the controller to the desired
location and screw the knob (closed)in place.
Figure 1
Figure 2

Advertisement

Table of Contents
loading

This manual is also suitable for:

790.4927