Kenmore ELITE 141.16732900 Use And Care Manual page 13

Water supply and
Island Assembly.
drainage system for
Faucet Operation
[] With the water and drain pipe fitted to a suitable outlet, be
sure the water and drain inlet/outlet connection fittings are
tightened securely.
[] Turn on the main water supply line.
[] Push the lever on the Faucet to the left to release
the water.
/
Outlets for Faucet
and Drain Pipe
For illustration purposes
the left cart side panel is
not shown.
Lever
/
Proper care and maintenance will keep your module in top oper-
ating condition and prolong its life. Follow these cleaning proce-
dures on a timely basis and your module will stay clean and
operate with minimum effort.
Cleaning Manufactured Stone Surfaces:
[] If needed, we suggest you wash the manufactured stone
surface using a mild soap and warm water solution only.
You can use a soft soapy cloth or sponge then rinse with
water. Never use abrasive cleaners, any cleaner contain-
ing bleach, scrubbers or stiff wire bushes on the stone
surface.These can cause discoloration and/or chipping
of the painted surface.
Cleaning Exterior Stainless Steel Surfaces:
[] Routine care and maintenance is required to preserve the
appearance and corrosion resistance of stainless steel. The
fact is stainless steel can corrode, rust and discolor under
certain conditions. Rust is caused when regular steel par-
ticles in the atmosphere become attached to the stainless
steel surface. Steel particles can also become attached to
your module if you use steel wool or stiff wire brushes to
clean the module instead of non-abrasive cloth, sponge or
nylon cleaning tools. In coastal areas rust pits can develop
on stainless surfaces that cannot be fully removed. Bleach
and other
chlorine based solutions used for household and pool clean-
ing can also cause corrosion to stainless steel. Weather-
ing, extreme heat, smoke from cooking and machine oils
used in the manufacturing process of stainless steel can
cause stainless steel to turn tan in color. Although there are
many factors which can affect the surface appearance of
stainless steel, they do not affect the integrity of the steel or
the performance of the module.
[]
1.
To help maintain the finish of stainless steel follow these
cleaning procedures for the best results:
After every use, wipe stainless surfaces with a soft, soapy
cloth or sponge then rinse with water. Be sure to remove all
food particles, sauces or marinades from stainless steel
because these can be highly acidic and damaging to stain-
less surfaces.
2. Never use abrasive cleaners, scrubbers or stiff wire
brushes of any type on your module.
3. Use a heat resistant Stainless Steel Cleaner and rub or
wipe in the direction of the stainless steel grain or polish
lines NOT against the grain.
13