Kenmore 14048 Owner's Manual page 14

Common D[shwash[ng Problems and Solutions
(continued)
Problem
Spotting and
filming
Etching--permanent
filming which
cannot be removed
Water left in bottom
of tub
Caused by Solution
HaM water
Water' is not hot
COOL. DRY drying
option selected
Not enough or' poor
quality detergent
Old detergent
No rinse agent
Too much detergent
in soft water'
Improper loading
Nmmal amount of
water
Drain air' gap
Fill detergent cups to capacity. Use dishwasher detergent
with highest available phosphorous content, May be
necessary to install a water softener°
Raise water heater thermostat to 140°E
Drying without heat may cause some spotting, Do not select
COOL. DRY option,
Use more fresh automatic dishwasher detergent° Use
detergent with highest available phosphorous content,
especially if you have hard water.
Use only flesh, automatic dishwasher detergent. Store tightly
closed in a cool, dry place, Discard old, lumpy or separated
detergent. Do not fill detergent dispensers until ready to wash.
Fill rinse agent dispenser,
To remove stubborn spots and film from glassware:
!. Remove all metal utensils flora the dishwasher'.
2 Do not add detergent.
3. Select HEAVY WASH cycle,
4o Start the dishwasher and allow to run for 18 to 20 minutes.
The dishwasher' will now be in the main wash,.
5.,Then open the door and pour 2 cups (500ml) white
vinegar' into bottom of dishwasher.
6. Close the door and allow to complete the cycle.
If vinegar rinse doesn't work: Repeat as above, except use
1/4 cup (60ml) of citric acid crystals instead of vinegar.
(Most drugstores carry citric acid crystals:)
Reduce amount of dishwasher detergent,, Use detergent with
lower phosphorous content.
Make sure dishes and glassware are loaded properly to permit
water spray to rinse all surfimes° Do not overload.
It is normal for' a small amount of clean water to remain in
bottom of tub after each cycle
Clean the &ain air gap. See User' Maintenance insuuctions.
14