Table of Contents
Advertisement
WARNING
• ALL
RANGES
CAN TIP
• INJURY
COULD
RESULT
• INSTALL
ANTI-TIP
DEVICE
PACKED
WITH
RANGE
• SEE
INSTRUCTIONS
TOOLS NEEDED:
STABILITY
DEVICE
INSTALLATION
INSTRUCTIONS
FOR
BRACKET
KIT
NO.
342473
PhUlips head screwdriver
1-3/8" open end or adjustable wrench
Bracket attaches to floor or wall to hold either right o r left
rear leg leveler. If fastening to floor, be sure that screws
do not penetrate electrical wiring or plumbing.
If this
cannot be determined,
use shorter screws that will not
penetrate
through flooring.
If the bracket came with your range, It Is shipped at-
tached to the lower range back. Remove and discard
the shipping
screw that holds the bracket and then
follow instructions
below.
1. Decide whether the bracket will be Installed on the
right or left side of range location.
2. If the bracket side of the range Is adjacent
to a
cabinet,
place the bracket against
back wall and
cabinet as shown in Figure 1.
If there is no adjacent cabinet, determine where the
location of the range side (painted outside panel) will
be. Place the bracket with Its outside edge at this
location and against back wall. See Figure 1.
.
4.
5,
Determine whether you will anchor the bracket to the
floor or wall. Fasten the bracket securely with the
screws provided. Screws are self-drilling
in wood,
plywood, particle and chip board, and most metal
framing. If attaching to masonryyou
can buy suitable
screws
and anchors
at hardware
stores.
Use a
masonry
drill to drill the required holes.
Using the wrench, back out the four leg levelers at
least two turns. See your Installation guide for more
leveling InformaUon before positioning
range.
Slide the range into place. Be sure rear leg leveler
fully engages
slot In bracket. If range cannot be
moved back far enough for rear leg leveler to enter
bracket, move bracket forward as required and attach
to floor in new location.
ADJACENT
CABINET
OR FINAL
LOCATION
OF RANGE
SIDE
PANEL
OUTSIDE
EDGE OF
BRACKETTO BE
FLUSHWITH LEFTOR
RIGHT SIDE OF RANGE
\
WALL BEHIND
RANGE
BRACKET
SCREW MUST ENTER_
WOOD OR METAL
WALL
PLATE
/
ATTACHMENT
TO WALL
Fig. 1
Fig. 2
4
NCINS01
Advertisement
Table of Contents
