Loading Film - Nikon One touch zoom Instruction Manual

Loading film
g
Use DX-coded 35mm film (IS0100,200,400 or 1000). The film
speed is set automatically. With non DX-coded film, film speed is
set at ISO 100.
1 Open the camera back in the direction of the arrow.
2 Insert the film cartridge in the direction shown in the figure,
putting the bottom part in first.
3 Pull the film leader across a few centimeters, align it with the
yellow film mark, just beyond the film take-up spool, and set it
in the film guides. Ensure that the film is not slack.
4 Close the camera back until it clicks. The film is then
advanced to the first frame. Be sure to turn the power ON and
check that "1" appears in the frame counter after loading the
film.
Should the "E" sign blink in the frame counter when the power is
switched ON, open the camera back again and adjust the film
correctly.
With non DX-coded film, an unblinking "E" sign appears in the
frame counter.
Note: When loading the film, avoid exposure to direct sunlight by
moving into the shade.