Making Local Site Settings; Registering A Local Site - Panasonic KX-VC500 Operating Manual

Making Local Site
Settings
You can register up to 5 temporary local sites. The
same unit can be used in multiple meeting rooms
without the need to change certain basic network
settings.

Registering a Local Site

1.
Press [Menu].
•
The Menu screen is displayed.
2.
Use [ ][ ] to select "Select local site" and
press [Enter].
•
The select local site screen is displayed.
3.
Use [ ][ ] to select "Not Registered" and press
[B].
•
The local site settings screen is displayed.
4.
Use [ ][ ] to select the following items for input:
"Local site name": Enter a name for the local site.
"IP Address": Enter an IP address.
•
If the IP address contains 1 or 2 digit numbers,
enter these numbers as they are. Do not enter
like [.001].
Example: The IP address is [192.168.0.1].
–
Correct entry: [192.168.0.1]
–
Wrong entry: [192.168.000.001]
"Subnet mask": Enter the subnet mask.
"Default Gateway": Enter the IP address of the
default gateway.
"Max. Bandwidth": Press [Enter] and use [
[ ] to select the maximum allowed bandwidth to
Document Version 2011-02
be used (512 kbps, 768 kbps, 1.0 Mbps,
1.2 Mbps, 2.0 Mbps, 3.0 Mbps, 4.0 Mbps,
5.0 Mbps, 6.0 Mbps, 7.0 Mbps, 8.0 Mbps,
9.0 Mbps [default], 10.0 Mbps).
Note
•
The maximum bandwidth during a video
conference call adjusts to that of the party
that has set the lowest bandwidth for the
maximum bandwidth setting among all
participating parties.
•
You cannot select a value that is higher than
the maximum bandwidth set by the dealer.
For details, contact your dealer.
•
When you make a 3-party video conference
call, select a value of "1.0 Mbps" or higher.
Otherwise, the image quality and the sound
quality cannot be guaranteed.
•
When you make a 4-party video conference
call, select a value of "2.0 Mbps" or higher.
Otherwise, the image quality and the sound
quality cannot be guaranteed.
"Encryption": Use [
enable encryption.
–
"ON": Encryption is enabled.
–
"OFF" (default): Encryption is disabled.
Note
•
Be careful when changing encryption
settings because doing so may cause you
to become unable to communicate with
other parties.
•
Be aware that if encryption is disabled,
eavesdropping might be possible on
networks that are not secured against such
actions.
•
If you cannot specify a value for
"Encryption" because the setting is
unavailable, contact your network
administrator.
•
When connecting to an MCU or
non-Panasonic video conference system,
set "Encryption" to "OFF" because
encryption is not available. Encryption must
be disabled on both sides.
"Max Resolution": Use [
maximum display resolution of the main video
camera and sub video camera used during a video
conference call.
– "Full HD": Maximum resolution: 1920 ´ 1080i
(This mode switches the display resolution
]
according to the condition of the network.)
"HD": Maximum resolution: 1280 ´ 720p
–
Contacts and Settings
][ ] to select whether to
][ ] to select the
Operating Manual 91