Performing A Network Test - Panasonic KX-VC500 Operating Manual

Contacts and Settings
•
When "ON" is selected, if the unit receives a
signal from a remote control that has an ID
different from the one specified on the Home
screen, a warning is displayed. Follow the
procedures on the screen to change the remote
control ID.
•
When "OFF" is selected, even if the unit
receives a signal from a remote control that has
an ID different from the one specified, no
warning is displayed on the Home screen.
Note
•
If multiple remote controls with assigned
IDs are being used close together, it is
recommended that you select "OFF" for
"Check ID mismatch".
6.
Press [G].
•
A dialog box to confirm the saving of settings is
displayed.
7.
Use [ ][ ] to select "Yes" and press [Enter].
8.
When "Remote ID enable" is set to
"ON" (Page 81):
The dialog box for changing the ID of the remote
control is displayed. Proceed to step 9.
Note
•
While the dialog box is displayed, video
conference calls cannot be received.
When "Remote ID enable" is set to
"OFF" (Page 81):
The system settings screen is displayed. Press
[Home] to return to the Home screen.
82 Operating Manual
9.
Use the following procedure to change the ID of the
remote control.
1.
Press and hold [·] and [#] at the same time.
2.
Within 2 seconds after you release the buttons,
press the number (1 to 3) corresponding to the
ID that you specified for "Remote control ID"
in step 4.
–
1: ID1
–
2: ID2
–
3: ID3
10.
Press [Enter].
•
The dialog box disappears and the remote
control ID of the unit will be saved.
Note
•
If the dialog box does not disappear, repeat
the procedure above, several times if
necessary. If the dialog box still does not
disappear, turn the power off and then back
on to cancel the settings. For details,
contact your dealer.
11.
Press [Home].
•
The Home screen is displayed.

Performing a Network Test

You can confirm whether a network connection can be
established with a particular IP address.
Note
•
You cannot perform a network test from the
contact list screen or the call history screen.
1.
Press [Menu].
•
The Menu screen is displayed.
2.
Use [ ][ ] to select "Settings" and press
[Enter].
•
The system settings screen is displayed.
3.
Press [ ].
•
The second page is displayed.
Document Version 2011-02