Advertisement
• Fold the edge inwards by the hem
width.
If the stitches are visible on the right side,
adjust edge guide B by turning adjusting
screw A.
Use the needle position
and the
width dial (24) to regulate the penetration
of the needle in the crease.
• Now unfold the hem again so that the
hem edge protrudes by about 1 cm
•
Place the fabric under the sewing foot
so that the crease line runs along edge
guide B.
• Using the needle positioning knob 28,
select the needle position to the right
• When the needle enters the crease
line, it must only pick up one fiber of
the fabric.
UtiIiiy stitches and practical sewing
Remember!
When blind stitching, if you select a needle
position other than right, f and stitch
width other than 5, make sure the needle
does not strike the bar of presser foot 3.
B
I
H
5-
1-2
•
3-5
0/3
Blind stitch (elastic)
Stitch H is a blind stitch for woven or
elastic materials. The hem is sewn and
overcast at the same time.
Stitch H
Advertisement
