Advertisement
Notes on safety
Notes on safety for household sewing machines in accordance with
EN 60 335-2-28 and IEC 60 335-2-28
1
The user must exercise adequate caution
with regard to the up and down movement
of the needle and must constantly observe
the sewing area while sewing.
2.
When leaving the machine unattended,
during maintenance work or when
replacing mechanical parts or accessories,
always disconnect the machine from the
mains by pulling out the mains plug.
3.
The maximum permissible wattage for the
sewing lamp is 15 watts.
4.
The tension of the drive belt must only be
adjusted by a PFAFF mechanic.
5.
The machine must be operated in
accordance with the indications on the
specification plate.
6.
Do not insert any objects into openings on
the machine.
7.
Do not use the sewing machine it:
• there is visible damage
• its function is disturbed
• it is wet, eg with condensation which can
occur when a cold machine is brought into
a warm room.
8.
Do not pull the mains plug out of the socket
by its cord.
9.
If this appliance is used for another
purpose than that for which it is intended or
if it is wrongly operated, we cannot accept
any liability for any damage caused.
10. To avoid the risk of electric shock, do
not open the machine. There are no parts
inside the machine which the user can
repair. Repairs are solely the responsibility
of our qualified service staff.
11. Be sure to use only original PFAFF parts.
12. The machine is designed for a mains
supply with a nominal voltage of +1- 10%
and a rated frequency of +7- 4%.
13. When used properly the temperature of the
outer components of a non-electronically
controlled foot control can reach up to
85C. Constant use at a low speed is
therefore not permitted in order to avoid
damage.
Environment
The recommended environment is:
Ambient temperature 1 0C to 40C
Humidity 20°c to 80°c
Storage temperature: -25C to +60CC
The machine is suppressed and immune to
interference; however, it should not be operated
near electronic devices such as radios, TV5,
PCs, broadcasting transmitters, etc.
This sewing machine is a high-quality
electronic-mechanical device. It is a machine
for supervised use in the home. It should
not be subjected to: dust, dampness, direct
sunlight, static electricity, heat-radiating
objects, corrosive chemicals or liquids.
For ventilation purposes the machine must only
be operated on an open surface which is both
firm and horizontal.
Care of the machine
Always protect the machine from damage
which may be caused by it being hit or
dropped.
Cleaning
Housing and display:
To clean the housing, use only a clean, dry,
soft, lint-free cloth. To remove any stubborn dirt
use a soft cloth with alcohol.
Please note!
Do not use any insecticides or chemical
products such as petrol or liquid chemicals to
clean the housing.
Advertisement
