Needle Position; Changing The Needle - Pfaff hobbylock 4762 Instruction Manual

As shown in the illustration, up to two
needles can be inserted into the needle
holder. Retaining screw A belongs to the
right overedge needle, retaining screw B
to the left overedge needle.
Overedge needles for system EL X 705,
Cat. Nr. 2002 are required for this
machine. Lower the sewing foot with the
sewing foot lift and turn the handwheel
until the needle is at its highest point.
In this instructions manual the various
needle positions are shown in a schematic
drawing of the needle holder. See the
above examples.
Note:
If both the left and right overedge
needles have been inserted, the left
needle will be somewhat higher than the
right needle.
Loosen the needle fastening screw
(without removable it completely> with the
small screwdriver included in the accesso
ries and remove the needle in a downward
motion. Insert a new needle into the
needle holder with the flat side to the
rear and retighten the respective faste
ning screw.
A
right
overedge
needle
threaded
B
left
overedge
needle
threaded
Needle position
left and right
overedge needles
threaded
Changing the needle
Switch off at the mains switch.
11