Table of Contents
Advertisement
3.3.
Main Menu
The main menu lists the input channel select item, 6 sub menus, and a menu item for automatic setup
of VGA modes. The 6 sub menus are Output, Colour, Geometry, PiP (HQView-500S) or Multiple Unit
(HQView-510 and 520/530), Enhancement and System.
On each menu page an Exit menu item is available to leave the menu or submenu.
HQView-500S/510 and 520 also allow to leave (back up) a menu or submenu by pressing the up/down
key simultaneously. HQView-530 has a separate back key for this purpose.
Some adjustments are not applicable to all signal types or operating modes, in which case those non-
applicable functions will be ghosted (greyed out) and are not accessible.
All menus have a top status line and a bottom firmware revision line.
In the status line the currently selected input channel is indicated and the detected mode is identified.
The bottom line shows the revision number of the boot loader behind BL, the revision number of the
firmware behind FW and whether it is a 500S, 510, 520 or 530 type HQView unit.
Navigating the menu system or changing values is done with the Menu/Enter and up / down keys in the
case of HQView-500S, 510 and 520 or a Menu and Back keys together with a jog wheel/Enter in the
case of HQView-530.
In the following sections the set-up method using the up and down keys is described.
To set up your HQView-5xx it is recommended that you follow this procedure:
1/ Choose the correct output mode and parameters to suit your screen or projector.
2/ Select the correct input signal.
3/ Set the input levels and features appropriately to optimize the appearance of your image.
4/ Set any other parameters to suit your application.
Note: The processor is designed to have separate memories for all the settings in each section. All Input
parameters are specific to your chosen input channel and input signal type, they are not global to the
unit. If you change the settings in for example the composite video channel you will not affect the
settings you may have made in for example the DVI channel.
All Output parameters only affect the output, they do not affect any of the inputs but please note that the
appearance on the screen because it is the output these adjustments will appear to be global.
3.4.
Input
The list of available inputs can be scrolled through using the Up and Down keys or jog wheel. The new
input is not selected until the Menu/Enter key is pressed. The list of inputs are: CVBS 1, CVBS 2, S-
Video, Component, VGA, 3G-SDI, DVI, HDMI and Test Pattern.
Test patterns can be generated by HQView-5xx without needing an input connected. When Test Pattern
is selected as the input, the required test pattern can be chosen with the menu navigation up/down keys
or jog wheel when the OSD menu is off or the LCD menu is in its default screen.
3.5.
Output
This menu contains adjustments associated with setting up outputs from the unit. The items are
organized in three sub menus, Display Type, Gamma/Color/Crush and Output Config. Use the up and
down keys or jog dial to scroll to the required item and press the Menu key.
©
Calibre UK Limited Issue 2.30
nd
22
April 2013
16
Advertisement
Table of Contents
