Table of Contents
Advertisement
2.
3.
4.
Remove the access cover at the back of the grill by removing
the 4 screws at the back of firebox (2 on each side of the
rotisserie infrared burner).
-\\
\\\
\
A
A. Access cover
Using a Phillips screwdriver, remove the 2 screws holding the
spider guard to the burner.
I
\
A
A. 2 screws
Use 24 mm wrench to remove the orifice nut.
5.
Take out the orifice support, and then use a 6 mm socket and
wrench or 6 mm nut driver to remove the LP orifice at the end
of the supply pipe. Replace with Natural gas orifice.
A
A. Orifice support
B. Orifice
6. Reinstall the spider guard, access cover, and wind baffle.
7. Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
A. Closed valve
B. Open valve
8. Test all connections
by brushing on an approved
noncorrosive
leak-detection
solution. Bubbles will show a
leak. Correct any leak found.
9. The igniter battery is not factory installed. A "AA" size alkaline
battery is located in the accessory box on the grill grate.
Install battery at this time following the instructions
in
"Replacing the Igniter Battery" section.
10. Go to "Check and Adjust the Burners" section.
Record Conversion
The model/serial number plate is located on the right-hand side
of the grill. With a permanent marker, check the box next to
"Natural gas" and mark through "LR"
In the last page of the Use and Care Guide, write "Converted to
Natural Gas." Also record the conversion date and the
technician/company
that performed the conversion.
NOTE: Place the LP gas parts in plastic parts bag for future use
and keep with package containing the literature.
A. Orifice nut
14
Hide quick links:
Advertisement
Table of Contents
