Reversing Door Swing - Kenmore 3638799682 Owner's Manual

Reversing Door Swing
(continued)
Reversing hardware on cabinet
Step l--Transferring bottom hinge bracket to
the left side (continued),
(d) Reinstall the trim
plate on the bottom right
side of the cabinet, using
the Torx screws removed
in step (a) above.
TRIM PLATE
%
BOTTOM RIGHT
Transferring the center hinge bracket
Do not remove
this screw
%
Center right
(a) Remove the hinge bracket (and shim glued to it)
from the center right side of the cabinet by removing
the three outermost Torx screws_
(b)
Remove the three outermost Torx screws from the
center left side of the cabinet and screw them into the
holes at the right side uncovered in Step (a) above_
Center left L _
Do not remove
this screw
(c) Place the center hinge bracket over the holes at
the center left side of the cabinet, insert the screws
you removed from the opposite side, and tighten them_
Transferring the top hinge
Interchange hinge and screws at top right with
screws at top left of the cabinet. Do not tighten
the screws on the hinge side at this time.
Transferring doorstops
Doorstop
Left side Right side
(a) Remove metal doorstop on bottom right of
each door.
(b) Replace door stops on left side after handles
have been moved°
Transferring door handles
Freezer door
(e) Remove screw holding handle to top of door°
(b) Remove two screws holding handle to bottom of
door, (Some models have a third screw., Remove it, too.)
(€) Transfer screw from handle hole in top right of
door to opposite side.
(d) Transfer plug button in top left of door to
opposite side,
(e) In reverse order, reassemble handle to right side
of door using screws removed in Steps (a) and (b).
14