Kenmore 363.14672 Use & Care Manual page 16

PROBLEM
"Dishwasher
will not start
Dishwasher will
not fill with water
Unusual noise
Dishwasher
leaks
CAUSED BY
,Dishwasher not
receiving electricity
• Dial not in correct
position for cycle
selected
• Turning the Dial
too far
• Turning the Dial
too far
• No water supply
•Water inlet valve
clogged
• Improper loading
• Dishwasher not
level
• Too much sudsing
• Spilled rinse agent
• Dishwasher door
interferes with
surrounding
cabinets
SOLUTION
• Check house fuse or circuit breaker,
• Make sure Dial is turned far enough and
cycle button is fully pushed in.
• Turn Dia! to START. Be careful you do not
turn the Dial any farther than necessary.
There is a delay between start-up and water
fill so you will not hear any wash action
right away°
,See the solution above.
• Make sure water supply valve under sink is
turned on.
• Water valve supply line may be clogged with
sediment. Clean out.
=Utensils may not be secure on rack pins,
or something small may have dropped from
the rack. Water is caus;ng utensils to rattle.
Make sure everything is securely placed
in dishwasher_
• Level dishwasher as described in Installation
Instructions, Don't place dishwasher on carpet.
. Improper detergent, Use automatic
dishwasher detergent only or try a
different brand or less detergent.
-If hand dishwashing detergent is used by
mistake, pour one measuring cup of
vegetable oil in bottom of tub and run
dishwasher through a complete NORMAL
WASH cycle with recommended amount of
automatic dishwashing detergent.
-To remove suds from tub" Open dishwasher.
Let suds evaporate. Add 1 gallon of cold
water to tub. Close and latch dishwasher.
Pump out water by slowly turning Dial until a
drain period is reached. Repeat if necessary.
=Spilled rinse agent can cause foam during
washing. This can lead to overflowing° Wipe
up accidental spill of rinse agent with a
damp cloth.
• Make sure door does not touch cabinets
when opening or closing. Use levelling legs
to level dishwasher.
16