Do you have a question about the FFAD7033R1 and is the answer not in the manual?
Questions and answers
Jo strong
July 27, 2025
I need to replace my drainage joint that screws into the drainage connector I have lost my drainage joint . What part # is it
Terry Zuehlke
July 25, 2025
What is the pint capacity of the? Frigidaire FFAD7033R1?
Lewis Thorp
May 7, 2025
What actions can be done with an E3 error code?
Rachael Lowe
April 26, 2025
How much does it cost to have a technician to give me an estimate for a repair? I have provided two pictures. One shows the model and serial number and other shows the error code. I have already cleaned the filter and plugged it in to a different outlet. No buttons work when error code is on. If I unplug it and plug it back in it will turn on, but only for a minute.
Important Safety Instructions NOTE: This USE & CARE MANUAL provides specific operating instructions for your model. Use the dehumidifier only as instructed in this USE & CARE MANUAL. These instructions are not meant to cover every possible condition and situation that may occur. Common sense and caution must be practiced when installing, operating, and maintaining any appliance.
Installation, Location & How It Works Selecting a Location Location IMPORTANT: 1. Dehumidifier must be operated in an enclosed area to be most effective. Close all doors, windows, and other outside openings to the room. The effectiveness of the dehumidifier depends on the rate at which new moisture-laden air enters the room.
Operating Instructions Operating Instructions Allow the unit to reach room temperature before operating. To begin operating the dehumidifier, follow these steps: NOTE: Unit must be upright for one hour prior to operating. 1. Plug the power cord into a properly grounded 115 volt AC outlet. NOTE: If the "BUCKET FULL"...
Page 5
Operating Instructions Operating Instructions (continued) 4. You can also use the FAN SPEED button to change the fan speed to HIGH, Medium or LOW. The indicator light will show the setting you have selected. A higher fan speed will result in quicker moisture removal. 5.
41 °F (5 °C) to 90 °F (32 °C). Unplug the unit and plug it in again under normal operating conditions. If the "F0" code persists, contact your Authorized Frigidaire Service Center.
Operating Instructions Removing Collected Water 1. Emptying the Bucket: a. When the buc ket is full, the unit will shut down and the BUCKET FULL indicator will illuminate. The product have also added an additional bucket full indicator light to the front of the unit, this light will continually blink when the bucket is full, removed or not placed correctly.
Page 8
Operating Instructions Removing Collected Water (continued) 2. Continuous Drainage: a. Open the drain cover at the side of the unit and take out drainage joint from the top of the styrofoam packaging. (fig.1) b. Screw the drainage joint onto the threaded portion of the drainage connector of the unit securely. (fig.2&3) c.
Care and Cleaning & Storage Care and Cleaning Tabs 1. Filter a. Remove the filter every two weeks based on normal operating conditions. To remove the filter, pull the tabs and then take out the filter. Wash the filter with clean water then dry. Do not dry the air filter with electric hair dryer.
Air is moving through the dehumidifier. The fan noise is normal sound. The unit is placed on uneven surface or wooden floor. Refer to “Continuous Drainage” for proper installation of garden hose and drainage joint. WATER FLOWS INTO THE BUCKET, EVEN WHEN GARDEN HOSE IS EQUIPPED. If These Solutions Fail, Call 1-800-944-9044 For Frigidaire Service.
Major Appliance Limited Warranty Your appliance is covered by a limited one-year warranty and a limited 2-5 year warranty on the sealed system (the compressor, condenser, evaporator and tubing). For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions.
Need help?
Do you have a question about the FFAD7033R1 and is the answer not in the manual?
Questions and answers
I need to replace my drainage joint that screws into the drainage connector I have lost my drainage joint . What part # is it
What is the pint capacity of the? Frigidaire FFAD7033R1?
What actions can be done with an E3 error code?
How much does it cost to have a technician to give me an estimate for a repair? I have provided two pictures. One shows the model and serial number and other shows the error code. I have already cleaned the filter and plugged it in to a different outlet. No buttons work when error code is on. If I unplug it and plug it back in it will turn on, but only for a minute.