Kenmore 363.14585 Series Use & Care Manual page 11

PROBLEM
Silverware
stained
Bronze
tarnish on
silver plate
CAUSE
• Undissolved
detergent contacting
wet silverware
•Acidic or salty
food soils
• Silver plate worn
off exposing base
metal--takes on
bronze hue
SOLUTION
• Avoid spilling dry detergent on wet silverware Clean with silver polish
• Use RINSE & HOLD cycle, Certain foods left on silverware for extended periods
of time may cause pitting.
• Remove tarnish with silver polish,
Black or • Metal utensils • Load metal utensils so they do not rub against dishes Marks may be removed
gray marks rubbing against with mild abrasive cleanser and plastic scouring pad.
on dish dishes during wash
Dishware • Improper loading • Do not overload Load grasses in upper rack onlyo See Loading section for tips°
chipped or
broken
Dishwasher
odor :
Motor hums
Staining of
tub interior
• Soiled dishes
held too long
in dishwasher
•Vinyl rack coating
• Dishwasher has
not been used on
a regular basis
• Some detergents
contain colorant
(pigment or dyes)
• Some tomato-based
foods can stain
- Water vapor comes
through the vent by
the door latch during
drying and when
water is being
pumped out
• Dial not in
OFF position
Vapor at
the vent
Detergent
cup lid
won't latch
after adding
detergent
• Use RINSE & HOLD cycle if dishes will not be washed at end of day
• Plastic odor will be gone after several weeks use.
• If you do not use your dishwasher often, set it to fit! and pump out once
every week This will help keep the seal moist and the garbage disposer clear.
•This will discolor the tub interior with extended use,, Check the detergent
dispenser for signs of any discoloration, if dispenser is discolored, change to
detergent without any colorant,
• Using the RINSE & HOLD cycle after adding dish to the load can decrease
the level of staining.
• This is a normal occurrence
• Dial must be in OFF position for cup lid to close and latch properly, tf you
unlatch the door and open it to dry your dishes, the Dial does not advance
to OFF by itself.
11