Make a basic drawing as a mono-color design.
(_D Basic design
Place a piece of drawing paper over your original drawing,
The drawing should fit inside of the scanning area,
Make sure to put the black positioning dot on the drawing
paper in the upper left corner.
(_ Drawing paper
(_) Frame lines for scanning area
Mark the four aligning positions on the original design,
(_) Aligning positions.
Trace the area for the first color, using the black felt-tip
Fill in the area completely with the black felt-tip pen.
Write the sewing step, color, and type of stitch outside of
the scanning area with the yellow felt-tip pen so that you
can identify them easily. Remove the drawing paper from
(_) Sewing step
(_) Type of stitch