Scanning The Designs; Securing The Design Sheet; Scanner Sensitivity Dial - Kenmore SCAN 19000 Owner's Manual

Scanning the designs
• Securing the design sheet
The SCAN 19000 has a convenient integral scanner guide
tray with paper ctip,
Place a design sheet or drawing paper on the guide tray,
Lift the clip and insert the end of the design sheet under it.
C) Clip (_ Scanner guide tray
O Design sheet _ Starting position
• Scanning the designs
Place the image scanner on the left side of the design
sheet.
Press the _ key.
Press the START button on the left side of the image
scanner,
The red light turns on to show the scanner is ready for
scanning.
Slowly slide the scanner on the design sheet from left to
right until beep sounds once.
When scanning is completed, the red light will go off.
(_ Red light (_ Start button
You can finish scanning by pressing the _ key.
When the complete design image appears on the screen,
stop scanning and press the _ key.
(You de not need to scan the remaining blank area.)
NOTE:
Make sure to keep the scanner flat on the scanner guide
tray. Do not tilt it up at an angle while scanning.
If the scanning speed is too fast, the screen displays
"Slide the scanner slower.".
Press the start button and scan again more slowly.
If the scanning speed is too slow, the screen displays
"Time is over ! Start from the beginning.",
Press the start button and scan again more quickly.
NOTES:
You have 30 seconds to complete the scan.
Slide the scanner straight from left to right.
The best scanning speed is about 1/2 "(1 cm) per second.
Remove any dust from the underside of the scanner with
a soft cloth,
• Scanner sensitivity dial
The result of the scanning varies depending on the
darkness of the drawing and the color of the drawing paper.
If the scanned image is not clear enough, adjust it by
turning the sensitivity dial and rescan.
If the scanned image is too dark:
Turn the dial in the direction A.
If the scanned image is too faint:
Turn the dial in the direction B.
Q j; Scanner sensitivity dial
12
__,_=Sli_e the scanner
s]oNer.
_ ime is over !
Start from
the beg inni ng.
Q
J