Delta RS830 Instruction Manual page 16

6. When both right and left edges of the table board
are the same distance from the table supports, tighten
four screws located in holes (N) Fig. 21, of front table
board (A).
7. Insert four 1/4-20x1-1/4" round head screws (P) Fig.
22, into holes (R) Figs. 21 and 22, of the table board as
shown, and tighten each of the screws until each corner
of the table board raises approximately 1/8".
8. Loosen bevel clamp lever (S) Fig. 23, pull out bevel
index knob (T), and rotate motor (V) to the vertical
position as shown, until bevel index engages. Then
tighten bevel clamp lever (S). NOTE: If the motor shaft
contacts the table board before the motor is fully
rotated, raise the track arm (X)Fig. 24, by turning
elevating handle (C).
9. Loosen cutting-head clamp knob (W)Fig. 23, and
move cutting-head to the front of track arm (X). Then
tighten cutting-head clamp knob (W).
Fig. 21
Fig. 22
Fig. 23
10. Loosen track arm clamp handle (Y) Fig. 24. NOTE:
Track clamp handle (Y) Fig. 24, has left handed threads.
Press down on indexing release handle (Z) Fig. 24, and
pivot track arm (X) Fig. 24, to the left until motor shaft (B)
Fig. 25, is near front left adjustment screw (P) Fig. 25, of
table board (A) Fig. 25, as shown. Then tighten track arm
clamp handle (Y) Fig. 24.
16
Fig. 24