Table of Contents
Advertisement
Cleaning
the Appliance
(Continued)
AUTOMATIC
LOCK OFF OF THE SURFACE ELEMENTS (30" models
with
a self-cleaning
oven
only)
During the self-clean cycle, the surface elements, when used, are subjected to high heat. To ensure maximum element life, a safeguard
locks off the use of the surface elements during the self-clean cycle. Once the oven cleaning cycle is complete and the oven door can be
opened, the surface elements can be utilized.
What to Expect During Cleaning
While the oven is in operation, the oven heats to temperatures much higher than those used in normal cooking. Sounds of metal
expansion and contraction are normal. Odor is also normal as the food soil is being removed. Smoke may appear through the oven
vent, located on the top of the control panel.
If heavy spillovers are not wiped up before cleaning, they may flame and cause more smoke and odor than usual. This is normal
and safe and should not cause alarm. If available, use an exhaust fan during the self-cleaning cycle.
NOTE: A smoke eliminator in the oven vent converts most of the soil into a colourless vapor.
Setting
the Controls
for a Clean Cycle
For the setting of the clean cycle, refer to the section on the timer or Electronic oven control.
To Remove and Replace the Oven
Door
1. Open the door fully.
2. Pull up the lock located on both hinge supports and engage them in the hook of the hinge levers. You may have to apply a
little downward pressure on the door to pull the locks fully over the hooks.
3. Grab the door by the sides, pull the bottom of the door up and toward you to disengage the hinge supports.
Keep pulling the bottom of the door toward you while rotating the top of the door toward the range to completely disengage
the hinge levers.
4. Proceed in reverse to reinstall the door.
Make sure the hinge supports are fully engaged before unlocking the hinge levers.
in normal
position
O
Lock engaged
for door re-
moval
HINGE
SLOT
Door
removed
from
the
range
17
Advertisement
Table of Contents
