Beforecallingforservice; Oven Light Bulb - Kenmore 911.41389 Owner's Manual

BEFORECALLINGFORSERVICE
To save you time and money, before making a service call check the list below
for any problem you may feel you have with the performance of your oven. If
the problem is something you cannot fix, use the Consumer Service Numbers
located at the back of this manual. When making any calls, have the
Model No., Repair Parts list, Use and Care Manual and the Date
of Purchase available.
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
The display of your
control is flashing
"F" followed by a
number or letter.
(Upper Oven)
Oven malfunction. Press the CLEAR/OFF
pad. Let the oven cool for
1 hour and enter an oven
or cleaning operation. If
code repeats, call for
service.
Oven and oven
control will not
work.
No power to oven.
Check the circuit breaker
or fuse. Make sure the
power cord is plugged in.
Oven temperature Thermostat calibration. See the adjustments
seems inaccurate, described following this
section.
Oven will not Clean cycle is not
unlock, finished.
(Upper Oven)
Oven temperature must
drop below the lock
temperature before the
door will unlock.
Oven light will
not work.
a, Light switch is in a, Check oven light
off position, switch on the control
panel.
b, Oven light bulb b, Check the oven
burned out. light bulb.
Oven did not
clean or results
were poor.
(Upper Oven)
a, Controls were not set
properly.
b, Clean cycle was
interrupted.
c. Oven was soiled
heavily.
22
a, Check the self-cleaning
section of this manual.
b, The normal clean cycle
should last 4 hours.
c, Heavy spillovers
should be removed
before the cycle is set.
You can also repeat
the cycle.