Table of Contents
Advertisement
Care & Cleaning
To Remove
and Replace
Oven Door
To Remove Oven Door:
1.
Open the door.
2.
Remove screws located on the inside of the oven door near the hinges A (one on each
side.)
3.
Close the door to the quarter-open position. Grasp the door firmly on both sides and lift up
and off the hinges.
4.
To clean oven door, follow the instructions provided in the Care & Cleaning
table.
To Replace Oven Door:
1.
Be sure the hinge arms are
2.
3.
4.
in the quarter-open position. Be careful if pulling the hinges
open by hand. The hinges may snap back against the oven frame and could pinch fingers.
Hold the door at the sides near the top. Insert the hinge arms into slots at the bottom of the
door.
Hinge arms must go into the range slots evenly. The hinge arms should be inserted into
the bottom corners of the door as far as they can go.
If the door is not in line with the oven frame, remove it and repeat the above steps.
The door is heavy. For safe, temporary storage, lay the door flat with the inside
of the door facing down.
Care and Cleaning
of Stainless
Steel
(some
models)
Some models are equipped with stainless steel exterior parts. Special care and cleaning are required
for maintaining the
appearance of stainless parts. Please refer to the table provided at the beginning of the Care & Cleaning section in this Use
& Care Guide.
Adjusting Your Oven Temperature
You r oven control has been precisely set at the factory. This setting may differ from your previous oven however, so your recipe
times may not give you the results you expect. If you think that the oven is cooking too hot or too cool for your recipe times,
you can adjust the control so that the oven cooks hotter or cooler than the temperature
displayed.
To Adjust Oven Temperature:
1.
Press _.
2.
Set the temperature to 550°F (287°C) by pressing and holding the
A
.
3.
Within 2 seconds, press and hold _
until the 2 digit display appears. Release _.
The display now indicates the
amount of degrees offset between the original factory temperature setting and the current temperature setting. If the oven
control has the original factory calibration, the display will read "00."
4.
The temperature can now be adjusted up or down 35°F (17°C), in 5°F steps by pressing and holding the
A
or v
.
Adjust until the desired amount of offset appears in the display. When lowering the oven temperature, a minus sign (-) will
appear before the number to indicate that the oven will be cooler by the displayed amount of degrees.
5.
When you have made the desired adjustment, press _
to go back to the time of day display.
Note: The adjustments made will not change the self-cleaning temperature.
2O
Advertisement
Table of Contents
