Kenmore 79098052004 Installation Instructions Manual

iNSTALLATiON AND SERVICEMUST BE PERFORMED BY A QUALiFiED iNSTALLER.
iMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or
use
gasoline or other
Nammable vapors and liciuids in the vicinity of this or any other appliance.
. Clearances and Dimensions
a. Provide adequate clearances between the range and adjacent combustible surfaces.
b. Location--Check location where the range will be installed. Check for proper electrical supply and the stability of floor.
c. Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface
must be solid and level.
United States
FRONT TYPICALCABINET INSTALLATION ...... SIDE
ViEW
VIEW
Minimumto 1" €'
wall on either
side of range
above 36" height,
L
Minimum*
__ Maximumdepth
for cabinets
above range top.
E
'q_301/8"_
F
t Minimumto
18" cabinets on
_ either side
of range.
O"clearance below cooking top and at rear of range.
f
36 + 118"
* 30" minimum clearance between the top of the cooking surface
and the bottom of an unprotected wood or metal cabinet; or 24
" minimum when bottom of wood or metal cabinet is protected
by not tess than 1/4" flame retardant millboard covered with not
less than no. 28 MSG sheet steel, 0.015" stainless steel, 0.024"
aluminum or 0.020" copper. The minimum clearance is 0" for the
rear of the range. Follow all dimension requirements provided
above to prevent property damage, potential fire hazard, and
incorrect countertop and cabinet cuts.
Avoid locating cabinet storage space above the surface units to
eliminate the possibility of cabinets catching on fire, or personal
burns from reaching for the cabinets over the heated units, if
cabinet storage is to be provided, risk can be reduced by installlng
a range hood that projects horizontally a minimum of 5" beyond
the bottom of the cabinets.
important Notes to the Installer
1. Read all instructions contained in these installation
instructions before installing the appliance.
2. Remove all packing material before connecting the electrical
supply to the appliance.
3. Observe all governing codes and ordinances.
4. Be sure to leave these instructions with the consumer.
BACK
ViEW
Important Note to the Consumer
Keep these instructions with your Use and
Care Guide for future reference.
Printed in Canada 318201732 (1202) Rev. C