Needle Timing To Shuti'le - Kenmore 385.15108200 Service Manual

SEWING MACHINE DIV. 20 MODEL 385. 15108200
MECHANICAL ADJUSTMENT
NEEDLE TIMING TO SHUTTLE
MACHINE SE'N'ING
1. STITCH SELECTOR: = C i 3".
TO CHECK:
1. OPEN THE SHU'i-rLE COVER.
2. REPLACE THE NEEDLE WITH THE TEST PIN #68368 (A).
3. REMOVE THE SHUTTLE HOOK, AND INSERT THE RADIAL TIMING GAUGE #68366 (B)
ONTO THE SHU'FI'LEDRIVER.
4. TURN THE HANDWHEEL TOWARD YOU BY HAND UNTIL THE NEEDLE BAR
REACHES ITS LOWEST POSITION.
5. THE TIP OF THE TEST PIN #68368 (A) SHOULD BE IN BETWEEN THE TWO VERTICAL
LINES ENGRAVED ON THE RADIAL TIMING GAUGE #68368 (B).
ADJUSTMENT PROCEDURE:
1. REMOVE THE BELT COVER AND THE FRONT COVER.
2. LOOSEN THE SCREWS (C) AND (D).
3. ROTATE THE SHUTI'LE DRIVER UNTIL THE TIP OF THE TEST PIN #68368 (A) COMES
IN BETWEEN THE TWO VERTICAL LINES ENGRAVED ON THE RADIAL TIMING
GAUGE #68366 (B).
4. TIGHTEN THE SCREWS (C) AND (D) SECURELY.
5. ATrACH THE FRONT COVER, THE BASE PLATE, AND THE BELT COVER.
THIS END OF THE (B) #68366
SHUTTLE HOOK
DRIVER SHOULD BE I
TOUCHING TO
I #68368
THE GAUGE
(o)
I
I
I
L
J
21