Presser Bar Height Alignment - Kenmore 385.15108200 Service Manual

SEWING M ACHINE DIV. 2 0 MODEL 3 85. 1 5108200
MECHANICAL ADJUSTMENT
PRESSER BAR HEIGHT AND ALIGNMENT
TO CHECK:
1. RAISE THE PRESSER FOOT LEVER (A).
2. THE DISTANCE BETWEEN THE PRESSER FOOT (D) AND THE NEEDLE PLATE (E)
SHOULD BE
6.0aM (0.24").
ADJUSTMENT PROCEDURE:
1. REMOVE THE SCREW (B), AND TAKE THE LAMP SOCKET OFF.
2. RAISE THE PRESSER FOOT LEVER, AND LOOSEN THE SCREW (C) ON THE PRESSER
BAR
HOLDER.
ADJUST THE DISTANCE BETWEEN THE PRESSER FOOT (D) AND THE NEEDLE PLATE
(E)TO
6.0MM (0.24").
3. TIGHTEN THE SCREW (C) SECURELY.
4. TIGHTEN THE SCREW (B) TO SECURE THE LAMP SOCKET.
NOTE: WHEN YOU TIGHTEN THE SCREW (B), MAKE SURE THAT BOTH SIDES OF THE
PRESSER FOOT ARE PARALLEL TO THE FEED DOG SLOTS (F) ON THE
NEEDLE
PLATE.
(#)
(c)
(A)
if)
(o)
14