Advertisement
Water Fill (continued)
Notice the water bottles are designed as
right'and
left:! hand units.: Position them in
_e _correct iocation ;so the humidifier:can
function
properly. The waterbottles should
rest in the front of the cabinet. Each"E-Z-
Fill Side:Cap" must be:facing the rear of
the unit.
Each water bottle is designed: with an "E-
Z-Fill Side-Cap" that is easily removable.
Remove the "E-Z-Fill Side-Cap"
on the
side of the water bottle by twisting coun-
terclockwise.
Place the opening of the water bottle under
a water faucet [the bottle should fit under a
four-inch clearance faucet). Fill with rec-
ommended
mixture
of cold water
and
Sears Bacteriostat
#42-14900
(if neces-
sary) only, Solid debris could make the
valve leak.
....
Install the "E-Z-Fill Side-Cap" by twisting
clockwise, Hand tighten only.
Check for possible leaks by performing
the following:
1. Grasp bottle handle and hold the bottle
uPright over a sink_
2. Press up on valve Cap plunger for about
one second to let out a little water.
3. Release the plunger.
4. Listen foi_ air btibbles.
Look for leaks
around the "E-Z-Fill Side-Cap".
5. If you hear air bubbles or see leaks,
retighten the "E-Z-Fil!
Side-Cap"
and
: : i_epeat Steps_i_4!:i: ;
: Wipel off excess W_te_ from the bottle.
Posit_on the Water. botUe back into the unit
; by
graspir_ the water bottle handle and
0wer.ff into the cabinet until the bottlesits
.
" on padsat b0ttom ofcabinet. "rhe "E-Z-Fiil
;
-: iSide-Cap" must i0e facing the rear of the
:cabinet.
when:positioned
pr0perly, the
plunger
will 0pen:and Water will flow into
: the cab net The :water evei wilt automati-
cally remain at approximately 1/2" until the
bottles areempty. _=i ....
The unit is now ready for operation.
"E-Z-Fill Side-Cap"
Should Always Face Rear
Turn Counterclockwise
ove Cap
Valve
Cap Plunger
Pivoting Lid
Removed
_
for Clarity
Advertisement
