Advertisement
i_
ii , IIIIIIII'IHII'IIIIII
I
I I I
II III IIII
WARNING
Electrical Shock Hazard
Unplug power cord from electrical
outlet.
Do not operate the cleaner
without the primary or exhaust fil-
ters.
Be sure the filters are properly
installed
to prevent motor failure
and/or electrical
shock.
PRIMARY FILTER
The filter CANNOT
be washed as it will
lose its dust trapping ability.
Check primary filter frequently
and clean
when dirty°
TO REMOVE PRIMARY
FILTER:
Remove the dust bin and dust bin lid
assembly as outlined in the DUST BIN
CLEANING
section.
Remove fit-
ter cover
by pushing
in at tabs
located
beneath
handle
hinges,
and lifting
off_
__
Filter
Cover
Tab
DUST BIN LID ASSEMBLY
Filter
Handle
Filter
TO REPLACE
PRI-
MARY FILTER
Replace filter and
rotate it until handle
drops into the slots.
Check sliders and
remove any obstruc-
tions
Grasp filter handle
and lift ouL
Clean primary filter
by gently tapping
over a trash con-
tainer.
Slots
/
Filter
Cover
Replace dust bin
lid by snapping
into place with
handle hinges
aligned to tabs,
Replace the dust bin as outined in the
DUST BIN CLEANING
section.
EXHAUST FILTER
HEPA
The exhaust filter cartridge
must be
replaced when dirty,
It should be replaced
regularly depending
on use conditions_ The
filter
CANNOT be washed as it will lose
its dust trapping
ability.
NOTE: See PARTS AND FEATURES
for the
exhaust filter part number
Press inward on
each side of
exhaust filter
cover and pull
out to remove
from vacuum
cleaner.
Exhaust
Press
Inward
Exhaust
Remove the
exhaust filter car-
tridge.
Replace the exhaust filter
cartridge,
carefully posi-
tioning it so that it fits into
the motor cover. The grey
edge of the filter
should
be facing
away from the
operator.
Push only on fil-
ter cartridge frame, not on
filter itself.
Replace the exhaust filter cover by placing
tabs in slots and pushing
in until cover
snaps into place°
17
Advertisement
