Removing Cartridges; Adjusting Surface Burner Low Flame Size - Amana AGDS902SS Owner's Manual

SmokeControl
Grill
TM
Install on right side only.
1. Turn controls to OFF position.
2. Remove grill from cartridge.
3. Place drip pan in well.
4. Place end of cartridge into range well with air
shutters facing rear of well. Lower front of cartridge
into well.
• Do not tilt cartridge too high. Lifting cartridge over
45 ° can cause damage to orifices.
5. Place grill grate on cartridge.
Grill
Drip pan
Removing Cartridges
1. Turn all controls to OFF. Make sure cartridge is cool.
2. Using tab on front of cartridge, lift up cartridge until
the bottom clears the range.
• Do not tilt cartridge too high. Lifting cartridge over
45 ° can cause damage to orifices.
3. Pull cartridge toward the front of range and carefully
lift it out.
Adjusting Surface Burner Low Flame Size
1. Push and turn burner control knob to LITEposition.
• Burner sparks until turned from LITE.
2. Set burner control knob to low setting.
3. Remove burner control knob.
4. While holding valve stem stationary, turn screw in
center of burner control stem until flame is adjusted.
• Use small blade screwdriver.
5. Replace burner control knob.
6. Turn surface burner control on and off to test burner
flame.
7. If flame is adjusted too low, flame may be easily
extinguished. Flame may be extinguished by drafts,
door opening or closing, heating and cooling vents,
ceiling fans, etc.
Installing Smoke Control Grill
TM
Installing Griddle
1. Turn controls to OFF position.
2. Install cartridge according to "Installing Smoke
Control Grill
TM
Cartridge" section.
3. With grease trap toward rear of range, place griddle
pan over burner.
• To remove griddle cartridge turn all controls to OFF
and reverse steps above.
Adjusting Low Burner Flame Size
Grease
Trap
Installing Griddle
18