Frigidaire LGBD2431LF0B Use & Care Manual page 4

Your dishwasher cleans by spraying a mixture of hot water and detergent through the spray arms against soiled surfaces.
Each cycle begins with a pre-drain. Next, the dishwasher fills with water covering the filter area. Water is then pumped
through the spray arms. Soil particles go down the drain as the water is pumped out and replaced with clean water. The
number of water fills will vary with the cycle being used. Features may vary by Model.
Nozzle and Upper SprayArm
TopRack
Tub Gasket
CupShelves
Bowlines
MiddleSprayArm
Lower Spray Arm
Overfill Protector
Serial Label
(located on right
side of tub)
Silverware
Basket
Bottom Rack
Glass Trap
Heating Element
Detergent Dispenser
Rinse Aid
Dispenser
Vent
Getting Started
1. Load dishwasher
2. Add detergent
3. Add rinse aid
4. Select desired CYCLE.The indicator light above the
pad will glow when selected.
5. Select desired OPTIONS. The indicator light above
the pad will glow when selected.
6. Run hot water faucet nearest dishwasher until water
is hot. Turn water off.
7. To start, press START/CANCEL pad.
8. Close door to latch.
The dishwasher is programmed to remember your last
cycle so you do not have to reset each time. To start the
dishwasher using the same cycle and options selected on
the previous wash, just press the START/CANCEL pad.